Jan 17, 2015

This recipe describes how to take the polarization measurement at injection.

 

Process:

 

simple instruction on switching polarimeter configuration in and out of injection mode:

switch to injection mode:

 


Use Vertical target2. On polarControl/target_measruement page, change Num Events from 40 millions to 10 millions. on polarControl/emittance_measurement page,make sure the start and end position range from 185000-195000.
ssh cnipol3
cd ado
cp new_set.ini.injection new_set.ini (answer y when asking for confirmation)

Switch out of injection mode:

 

When finished the injection measurements, reverse the above change. Namely:
On polarControl/target_measurement page, change Num Events from 10 millions to 40 millions. .
ssh cnipol3
cd ado
cp new_set.ini.flattop new_set.ini (answer y when asking for confirmation)
Switch back to normal target (Vertical target3).