Instruction
on Warm Snake control Haixin 3/4/04
The
pet page of the warm snake control is located at AGS/Location/E10_HOUSE/AGS_Warm_Snake. It is similar to many
power supplies pet pages.
To turn on the power supply, click
"On".To change it to
standby, click "Stby". If a fault displayed at
"statusStrongM",
one
may need to click "Stby" a few more times. There
is no need to change the ramp time (12s, which is the fastest it can go
from 0 to 2700A). The current can be changed with "setpoint". The two
readbacks
working right now are "Current[A]" and "Voltage [V]". The "Current
[A]" is off by about 7-10A from the set point, but the setpoint is the
value one should believe at the moment.
